Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1) › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404843 AIR FUEL RATIO SENSOR(for Sensor 1) A

M20A-FXS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
for M20A-FXS
·

Replacement of air fuel ratio sensor (sensor 1)

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344783

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.

·

Touching high-temperature areas such as the engine and exhaust manifold could result in burns.



PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55737B 2.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

Hide 55735A 3.REMOVE WATER GUARD PLATE LH (for TMC Made RHD)

Hide 55736D 4.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735C 5.REMOVE COWL BODY MOUNTING REINFORCEMENT RH

Hide 55701J 6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 55225 8.REMOVE DASH PANEL HEAT INSULATOR (for LHD)

Hide 55225 9.REMOVE DASH PANEL HEAT INSULATOR (for RHD)

Hide 89467B 10.REMOVE AIR FUEL RATIO SENSOR

CAUTION:
·
A344783

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.

·

Touching high-temperature areas such as the engine and exhaust manifold could result in burns.



a.
A439265

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 4 wire harness clamps.


c.
A394214N01
0.656,1.458 0.99,1.656 true 0.271,1.354 0.594,1.542 0.323,0.188 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold (TWC: Front Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.