Home › Engine / Hybrid System › M20A-FXS (COOLING) › WATER PUMP › from 2019.09
RM32K0E _51 Engine / Hybrid System _084057 M20A-FXS COOLING _0404850 WATER PUMP A

M20A-FXS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
for M20A-FXS
·

Cleaning the deposits from the throttle body with motor assembly

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16031 2.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 3.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A432187

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block sub-assembly.


b.
A402026

Remove the gasket from the engine water pump assembly (water inlet housing).