Home › Engine / Hybrid System › M20A-FXS (COOLING) › THERMOSTAT › from 2019.09
RM32K0E _51 Engine / Hybrid System _084057 M20A-FXS COOLING _0404851 THERMOSTAT A

M20A-FXS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 2.DRAIN ENGINE COOLANT (for Engine)

Hide 16572D 3.DISCONNECT NO. 2 RADIATOR HOSE

a.
A406659

Slide the clip and disconnect the No. 2 radiator hose from the water inlet with thermostat sub-assembly.


Hide 16031 4.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A432831

Disconnect the sensor wire connector.


b.

Disconnect the engine water pump assembly (water inlet housing) connector.


c.
A432832

Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).


d.
A432833

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.



HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.



e.
A432834

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


f.
A402018

Remove the gasket from the water inlet with thermostat sub-assembly.