Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › 2019.09–2020.08
RM32K0E _58 Vehicle Interior _062267 SUPPLEMENTAL RESTRAINT SYSTEMS _0303877 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 89170 1.INSTALL AIRBAG SENSOR ASSEMBLY

a.

Check that the power switch off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B458398

Install the airbag sensor assembly with the 3 bolts.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the power switch is first turned ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.




d.
B558592C01
0,0 0,0 false
V113147

Push in


Connect the 3 connectors to the airbag sensor assembly as shown in the illustration.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Check that there is no looseness in the installed parts of the airbag sensor assembly.


f.
B459829

Return the front floor carpet assembly and install the clip as shown in the illustration (for LH side).


g.
B459828

Return the front floor carpet assembly and install the clip as shown in the illustration (for RH side).


Hide 87212F 2.INSTALL REAR NO. 2 AIR DUCT (w/ Rear Air Duct)

a.
B460520C01
0,0 0,0 false
V113147

Install in this direction (1)
V113148

Install in this direction (2)


Engage the claws to install the rear No. 2 air duct as shown in the illustration.


Hide 3.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 7. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

a.

When the airbag sensor assembly is replaced, perform zero point calibration.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

HINT:

The yaw rate and acceleration sensor is built into the airbag sensor assembly.