Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › FLOW SHUTTING VALVE › from 2019.09
RM32K0E _51 Engine / Hybrid System _060780 2ZR-FXE COOLING _0298028 FLOW SHUTTING VALVE A

2ZR-FXE COOLING  FLOW SHUTTING VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during shutting valve (water valve) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control System) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


for 2ZR-FXE (for Nickel Metal Hydride Battery):(Click here)
for 2ZR-FXE (for Lithium-ion Battery):(Click here)
for 2ZR-FXE

Replacement of ECM


Perform Vehicle Identification Number (VIN) registration MIL comes on (Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide G9200 2.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 3.DRAIN ENGINE COOLANT (for Engine)

Hide 16671 4.REMOVE FLOW SHUTTING VALVE (WATER VALVE)

A375612

a.

Disconnect the 3 connectors.


b.

Disengage the clamp to disconnect the wire harness from the water outlet.


c.
A375613

Slide the clip and disconnect the No. 3 radiator hose.


d.
A375614

Slide the clip and disconnect the No. 9 water by-pass hose.


e.
A375615

Remove the 2 nuts.


f.

Slide the clip and disconnect the No. 10 water by-pass hose and remove the water outlet with the flow shutting valve (water valve).


g.

Remove the water outlet gasket from the cylinder head sub-assembly.


h.

Secure the water outlet in a vise between aluminum plates.

NOTICE:

Do not damage the water outlet.



i.
A375617

Remove the 2 bolts and flow shutting valve (water valve).


j.
A375618

Remove the gasket from the flow shutting valve (water valve).