The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel injector assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
25601L
4.REMOVE EGR PIPE WITH COOLER SUB-ASSEMBLY
12262
5.DISCONNECT NO. 2 VENTILATION HOSE
Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.
82121
6.DISCONNECT ENGINE WIRE
Disconnect the 4 fuel injector assembly connectors.
Remove the bolt.
Disengage the clamp to disconnect the engine wire.
23901
7.DISCONNECT FUEL TUBE SUB-ASSEMBLY
| *a | Open |
|
Pull |
Open the cover of the fuel pipe clamp and remove the fuel pipe clamp from the fuel tube connector.
Disconnect the fuel tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
23807
8.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Remove the bolt to separate the clamp of the fuel delivery pipe sub-assembly from the cylinder head sub-assembly.
Remove the 2 bolts and fuel delivery pipe sub-assembly with the 4 fuel injector assemblies.
Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe sub-assembly.
23807V
9.REMOVE NO. 1 DELIVERY PIPE SPACER
Remove the 2 No. 1 delivery pipe spacers from the cylinder head sub-assembly.
23250
10.REMOVE FUEL INJECTOR ASSEMBLY
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each fuel injector assembly.
Attach a tag or label with the corresponding cylinder number to each fuel injector assembly so that they can be installed to their original locations.
Cover the fuel injector assemblies with plastic bags to prevent damage and contamination.
Remove the 4 injector vibration insulators from the cylinder head sub-assembly.