The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
except GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except GR SPORT)>REMOVAL
for GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for GR SPORT)>REMOVAL
88215
2.REMOVE NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET
Remove the 2 bolts.
Disengage the guide to remove the No. 1 millimeter wave radar sensor bracket.
88211B
3.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
|
Bolt |
|
Screw |
Remove the 2 bolts and screw.
Disengage the guides and remove the millimeter wave radar sensor assembly.
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.