Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0304571 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P163081  Communication Error from VSC to ECM Invalid Serial Data Received  


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) sends signals such as brake request signals to the hybrid vehicle control ECU. If an abnormal signal is detected, the hybrid vehicle control ECU stores DTC P163081.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
P163081 Communication Error from VSC to ECM Invalid Serial Data Received When the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects abnormal data sent from the skid control ECU (brake booster with master cylinder assembly) for approximately 0.5 second or more.
·

Electronically controlled brake system

·

Hybrid vehicle control ECU


Cruise Control

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTCs
a.

Check for electronically controlled brake system DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Electronically controlled brake system DTCs are not output A
Electronically controlled brake system DTCs are output B



A

2.CLEAR DTC

B

2.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 399

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCs
3.CHECK FOR DTCs
a.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 399

Result:
Result Proceed to
DTC P163081 is not output A
DTC P163081 is output B



A

B