Home › Engine / Hybrid System › M20A-FXS (HYBRID / BATTERY CONTROL) › HYBRID VEHICLE CONTROL ECU › from 2020.08
RM32K0E _51 Engine / Hybrid System _083959 M20A-FXS HYBRID / BATTERY CONTROL _0404414 HYBRID VEHICLE CONTROL ECU A

M20A-FXS HYBRID / BATTERY CONTROL  HYBRID VEHICLE CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of hybrid vehicle control ECU Perform code registration (Immobiliser system)
·

Entry and start system

·

Wireless door lock control system

·

Hybrid control system cannot be started


See Service Bulletin for the registration method

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 82877 3.REMOVE ECU INTEGRATION BOX RH (for LHD)

Hide 82878 4.REMOVE ECU INTEGRATION BOX LH (for RHD)

Hide 89981 5.REMOVE HYBRID VEHICLE CONTROL ECU (for LHD)

a.
A443731

Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box RH.

NOTICE:
·

If the ECU integration box RH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.




Hide 89981 6.REMOVE HYBRID VEHICLE CONTROL ECU (for RHD)

a.
A443732

Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box LH.

NOTICE:
·

If the ECU integration box LH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.