The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
82877
3.REMOVE ECU INTEGRATION BOX RH (for LHD)
82878
4.REMOVE ECU INTEGRATION BOX LH (for RHD)
89981
5.REMOVE HYBRID VEHICLE CONTROL ECU (for LHD)
Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box RH.
If the ECU integration box RH is deformed or damaged, replace it.
Do not bend the 2 claws more than necessary.
89981
6.REMOVE HYBRID VEHICLE CONTROL ECU (for RHD)
Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box LH.
If the ECU integration box LH is deformed or damaged, replace it.
Do not bend the 2 claws more than necessary.