The forward recognition camera receives vehicle information from the hybrid vehicle control ECU via CAN communication. DTC U030051 is stored when the vehicle information from the hybrid vehicle control ECU cannot be confirmed.
The forward recognition camera receives the vehicle information from the hybrid vehicle control ECU via CAN communication. DTC U030057 is stored when the vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030051 | Internal Control Module Software Incompatibility Not Programmed | The forward recognition camera cannot confirm the vehicle information from the hybrid vehicle control ECU. | ·
Hybrid control system ·
Forward recognition camera ·
Hybrid vehicle control ECU |
| U030057 | Internal Control Module Software Incompatibility Invalid/Incompatible Software Component | The vehicle information from the hybrid vehicle control ECU and that stored in the forward recognition camera do not match. | ·
Hybrid control system ·
Forward recognition camera ·
Hybrid vehicle control ECU |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.
Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.
One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)
Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)
Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
Check for DTCs of hybrid control system.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for 2ZR-FXE (for NICKEL METAL HYDRIDE BATTERY): Click hereEngine / Hybrid System>2ZR-FXE (HYBRID / BATTERY CONTROL)>HYBRID CONTROL SYSTEM (for NICKEL METAL HYDRIDE BATTERY)>DIAGNOSTIC TROUBLE CODE CHART
for 2ZR-FXE (for LITHIUM-ION BATTERY): Click hereEngine / Hybrid System>2ZR-FXE (HYBRID / BATTERY CONTROL)>HYBRID CONTROL SYSTEM (for LITHIUM-ION BATTERY)>DIAGNOSTIC TROUBLE CODE CHART
Using the GTS, perform a health check.
DTCs indicating a vehicle information mismatch with that of the hybrid vehicle control ECU are not output by any ECU other than the forward recognition camera.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for 2ZR-FXE: Click hereEngine / Hybrid System>2ZR-FXE (HYBRID / BATTERY CONTROL)>HYBRID VEHICLE CONTROL ECU>REMOVAL
for M20A-FXS: Click hereEngine / Hybrid System>M20A-FXS (HYBRID / BATTERY CONTROL)>HYBRID VEHICLE CONTROL ECU>REMOVAL
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| HV/EV Equipped Information | Vehicle information (powertrain type) stored in forward recognition camera | Non-HV / HV/EV | Non-HV: Conventional vehicle
HV/EV: Hybrid vehicle |
- |
| Tester Display |
|---|
| HV/EV Equipped Information |
If the vehicle information stored in the forward recognition camera is different from the actual vehicle specifications, the vehicle information stored in the forward recognition camera may be incorrect. Replace the forward recognition camera.
If the vehicle information stored in the forward recognition camera matches the actual vehicle specifications, the installed hybrid vehicle control ECU is incompatible. Replace the hybrid vehicle control ECU.
| Result | Proceed to |
|---|---|
| Vehicle information stored in forward recognition camera and actual vehicle specifications do not match | A |
| Vehicle information stored in forward recognition camera and actual vehicle specifications match | B |
A
B
for 2ZR-FXE: Click hereEngine / Hybrid System>2ZR-FXE (HYBRID / BATTERY CONTROL)>HYBRID VEHICLE CONTROL ECU>REMOVAL
for M20A-FXS: Click hereEngine / Hybrid System>M20A-FXS (HYBRID / BATTERY CONTROL)>HYBRID VEHICLE CONTROL ECU>REMOVAL