Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0303861 PRE-COLLISION SYSTEM D

PRE-COLLISION  PRE-COLLISION SYSTEM  VEHICLE CONTROL HISTORY  


NOTICE:
·

Repairing or replacing related parts may cause Vehicle Control History (RoB) codes to be stored.

·

Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.



CHECK VEHICLE CONTROL HISTORY (PRE-COLLISION SYSTEM)


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Pre-Collision System / Utility / Vehicle Control History (RoB).

Body Electrical > Pre-Collision System > Utility
Tester Display
Vehicle Control History (RoB)
50005 432 1055

e.

According to the display on the GTS, read the Vehicle Control History (RoB).

Vehicle Control History (RoB)
Multi-information Display Code Tester Display Description Diagnostic Note
Pre-Collision System Malfunction Visit Your Dealer X2000 Yaw Rate Sensor Malfunction Recorded when a yaw rate sensor (airbag sensor assembly) malfunction signal was received from the yaw rate sensor (airbag sensor assembly). Perform troubleshooting for the electronically controlled brake system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2001 Steering Angle Sensor Malfunction Recorded when a steering sensor malfunction was detected. Perform troubleshooting for the electronically controlled brake system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2002 Accelerator Sensor Malfunction Recorded when a hybrid control system malfunction signal was received from the hybrid vehicle control ECU. Perform troubleshooting for the hybrid vehicle control system.
for 2ZR-FXE (for NICKEL METAL HYDRIDE BATTERY): Click here(Click here)
for 2ZR-FXE (for LITHIUM-ION BATTERY): Click here(Click here)
for M20A-FXS: Click here(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2003 Brake Control System Malfunction Recorded when an electronically controlled brake system malfunction signal was received from the skid control ECU (brake booster with master cylinder assembly). Perform troubleshooting for the electronically controlled brake system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2006 Buzzer Malfunction Recorded when forward recognition camera detects a malfunction in the pre-collision city buzzer. Front camera system (HOW TO PROCEED WITH TROUBLESHOOTING)
(Click here)
HINT:

While a buzzer malfunction is detected, if there is a possibility of a collision, the pre-collision brake assist and pre-collision brake functions will operate without sounding the buzzer.


Pre-Collision System Malfunction Visit Your Dealer X2012 Front Recognition Camera Malfunction Recorded when the forward recognition camera judged that it had a hardware malfunction. Perform troubleshooting for the front camera system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2013 Front Recognition Camera Optical Axis Misalignment Malfunction Recorded when the forward recognition camera judged that its optical axis was misaligned. Refer to DTC C1AA800 in Front Camera System
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2014 Front Recognition Camera Optical Axis Not Adjusted Recorded when the forward recognition camera optical axis alignment has not been performed. If this Vehicle Control History code is output, perform forward recognition camera optical axis adjustment, clear the Vehicle Control History and then check that this code is not stored again.
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition:(Click here)

Sequential Recognition:(Click here)

Driving Adjustment:(Click here)


Front Camera Low Visibility Unavailable See Owner's Manual X2015 Front Recognition Camera Dirt Recorded when system operation was temporarily suspended due to the forward recognition camera not being able to see ahead of the vehicle while driving. Refer to Vehicle Control History code X2015 of Front Camera System.
(Click here)
Front Camera Out of Temperature Range Unavailable Wait until Normal Temperature X2016 Front Recognition Camera Outside Guaranteed Operating Temperature Recorded when system operation was temporarily suspended due to the forward recognition camera being excessively hot or cold. Refer to Vehicle Control History code X2016 of Front Camera System.
(Click here)
Front Camera Unavailable See Owner's Manual X2017 Front Recognition Camera Outside Guaranteed Operating Voltage Recorded when system operation was temporarily suspended due to the forward recognition camera power source voltage being excessively high or low. Refer to Vehicle Control History code X2017 of Front Camera System.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2018 Front Recognition Camera Heater Malfunction Recorded when a malfunction in the forward recognition camera heater was detected. Perform troubleshooting for the front camera system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2020 Front Radar Sensor Destination Malfunction Recorded when a destination malfunction was detected in the millimeter wave radar sensor assembly. Perform troubleshooting for the front radar sensor system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2021 Front Radar Sensor Malfunction Recorded when a hardware malfunction was detected in the millimeter wave radar sensor assembly. Perform troubleshooting for the front radar sensor system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2022 Front Radar Sensor Optical Axis Misalignment Malfunction Recorded when beam axis misalignment of the millimeter wave radar sensor assembly was detected. Refer to DTC C1A1100 in front radar sensor system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2023 Front Radar Sensor Optical Axis Not Adjusted Recorded when it was detected that millimeter wave radar sensor assembly beam axis alignment had not been performed. If this code is output, perform millimeter wave radar sensor assembly beam axis adjustment, clear the Vehicle Control History and then check that this code is not output again.
HINT:

Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.

Triangle Target:(Click here)

Flat Surface Target:(Click here)

Driving Adjustment:(Click here)


Pre-Collision System Radar In Self Calibration Unavailable See Owner's Manual X2024 Front Radar Sensor Temporary Unavailable (Vertical Direction Optical Axis Misalignment) Recorded when system operation was temporarily suspended due to vertical misalignment of the millimeter wave radar sensor assembly beam axis. Refer to Vehicle Control History code X2024 of front radar sensor System.
(Click here)
Pre-Collision System Radar Sensor Blocked Unavailable Clean Radar Sensor X2026 Front Radar Sensor Dirt Recorded when system operation was temporarily suspended due to the millimeter wave radar sensor assembly not being able to detect objects while driving. Refer to Vehicle Control History code X2026 of front radar sensor system.
(Click here)
Pre-Collision System Out of Temperature Range Unavailable See Owner's Manual X2027 Front Radar Sensor Outside Guaranteed Operating Temperature Recorded when a sensor temperature abnormality determination was made due to excessively high or low temperatures. Refer to Vehicle Control History code X2027 of front radar sensor system.
(Click here)
Pre-Collision System Unavailable See Owner's Manual X2028 Front Radar Sensor Outside Guaranteed Operating Voltage Recorded when a sensor voltage abnormality determination was made due to excessively high or low voltages. Refer to Vehicle Control History code X2028 of front radar sensor system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2074 Communication Error from Pre-Collision System to Power Steering Control System Recorded when a communication malfunction was detected between the power steering ECU assembly and the millimeter wave radar sensor assembly. Perform troubleshooting for the power steering system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2081 Power Steering Control System for Steering Assist Invalid Recorded when steering assist control by the power steering ECU assembly was unavailable. Perform troubleshooting for the power steering system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X2082 Power Steering Control System for Steering Assist Steering Angle Malfunction Recorded when a steering assist angle malfunction from the power steering ECU assembly was detected. Perform troubleshooting for the power steering system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X202A Front Radar Sensor Destination Not Programmed Recorded when it was detected that the millimeter wave radar sensor assembly destination information had not been programmed. Perform troubleshooting for the front radar sensor system.
(Click here)
Pre-Collision System Unavailable See Owner's Manual X202B Front Radar Sensor Temporary Unavailable (Radio Wave Interference) Recorded when system operation was temporarily suspended due to nearby radar systems causing radio frequency interference with the millimeter wave radar sensor assembly. Refer to Vehicle Control History code X202B of front radar sensor system.
(Click here)
Pre-Collision System Malfunction Visit Your Dealer X203E Communication Error from Power Steering Control System to Front Recognition Camera System Recorded when a communication malfunction was detected between the power steering ECU assembly and the forward recognition camera. Perform troubleshooting for the power steering system.
(Click here)



CLEAR VEHICLE CONTROL HISTORY (PRE-COLLISION SYSTEM)


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Pre-Collision System / Utility / Vehicle Control History (RoB).

Body Electrical > Pre-Collision System > Utility
Tester Display
Vehicle Control History (RoB)
50005 432 1055

e.

According to the display on the GTS, clear the Vehicle Control History (RoB).

NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.




VEHICLE CONTROL HISTORY (AIRBAG SYSTEM)


a.

Part of the control history can be confirmed using the Vehicle Control History.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>VEHICLE CONTROL HISTORY