Home › Engine / Hybrid System › 2ZR-FXE (ENGINE CONTROL) › ECM › from 2020.08
RM32K0E _51 Engine / Hybrid System _060312 2ZR-FXE ENGINE CONTROL _0295702 ECM A

2ZR-FXE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89668 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89667E 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the 2 screws.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 89661 3.INSTALL ECM

a.
A394196C01
1.26,0.865 1.667,1.438 true 1.073,0.74 1.344,0.948 0.271,0.208 10 false *b 2.344,0.844 2.615,1.052 0.271,0.208 10 false *a
*a Torque Wrench Fulcrum Length
*b 10 mm Union Nut Wrench
V100135

Bolt
V100136

Nut


Using a 10 mm union nut wrench, tighten the nut.

Torque:
Specified tightening torque : 8.0 N*m (82 kgf*cm, 71 in.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

7.0 N*m (71 kgf*cm, 62 in.*lbf)




b.

Install the ECM with the bolt.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

If the ECM has been struck or dropped, replace it.



c.

Install the engine wire to the No. 1 ECM bracket with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.

Engage the 2 clamps.


e.
A375010

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:
·

When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water or other foreign matter.

·

Be sure to securely connect the ECM connectors.




Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART