Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › from 2020.08
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404841 ENGINE COOLANT TEMPERATURE SENSOR A

M20A-FXS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor or No. 2 engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


(Click here)
for M20A-FXS

Replacement of engine coolant temperature sensor


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
for M20A-FXS

ECM


Perform Vehicle Identification Number (VIN) registration MIL comes on (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 51444A 1.REMOVE REAR ENGINE UNDER COVER LH

Hide 2.DRAIN ENGINE COOLANT (for Engine)

Hide G9200 3.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 89422A 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A433111

Disconnect the engine coolant temperature sensor connector.


b.
A433112

Remove the clip and engine coolant temperature sensor from the water by-pass outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.