Home › Engine / Hybrid System › M20A-FXS (HYBRID / BATTERY CONTROL) › SERVICE PLUG GRIP › from 2020.08
RM32K0E _51 Engine / Hybrid System _083959 M20A-FXS HYBRID / BATTERY CONTROL _0404426 SERVICE PLUG GRIP A

M20A-FXS HYBRID / BATTERY CONTROL  SERVICE PLUG GRIP  INSTALLATION  


PROCEDURE

Hide G3834 1.INSTALL SERVICE PLUG GRIP

CAUTION:

Wear insulated gloves.


NOTICE:

Before installing the service plug grip, check that no parts or tools remain and that the high voltage terminals and connectors are connected securely.


a.

While wearing insulated gloves, and temporarily install the service plug grip as indicated by the arrow (1) shown in the illustration.

A371657N01
2.531,1.188 2.729,1.385 0.198,0.198 10 true 1 1.813,1.49 2.01,1.688 0.198,0.198 10 true 2 5.292,1.49 5.49,1.688 0.198,0.198 10 true 3


b.

Rotate the handle of the service plug grip 90° toward the HV battery and slide it in the direction indicated by the arrow (3) shown in the illustration until a click sound is heard to install the service plug grip.


Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART