The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the antenna cord sub-assembly removal/installation are shown below.
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55086
2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
86101
3.REMOVE ANTENNA CORD SUB-ASSEMBLY
Disengage the clamps to remove the antenna cord sub-assembly.
Disconnect the connector.
63311C
4.REMOVE ROOF HEADLINING
86101J
5.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
for Type A:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
for Type B:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
86101D
6.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
for Glass Antenna Type:
Disconnect the connector of the No. 4 antenna cord sub-assembly.
Disconnect the connector.
Disengage the clamps.
| *a | Guide |
| *b | Clamp |
Disconnect the connector of the floor wire.
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.