Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
Select "Failure Diagnosis" from the "Service Menu" screen.
Select "System Check" from the "Failure Diagnosis" screen.
Select "SPCheck ON" from the "System Check Mode" screen and perform speaker check.
Each speaker outputs sound from the selected audio source properly.
| Result | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 2 speaker assembly does not outputs sound | A |
| Rear speaker assembly does not outputs sound | B |
A
B
Disconnect the F132 radio and display receiver assembly connector.
Disconnect the I13 and J13 front No. 1 speaker assembly connectors.
Disconnect the F85 and F86 front No. 2 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F132-1 (FR+) - F85-4 (TWR+) | Always | Below 1 Ω |
| F132-6 (FR-) - F85-2 (TWR-) | Always | Below 1 Ω |
| F132-2 (FL+) - F86-4 (TWL+) | Always | Below 1 Ω |
| F132-7 (FL-) - F86-2 (TWL-) | Always | Below 1 Ω |
| I13-2 - F85-3 (+) | Always | Below 1 Ω |
| I13-1 - F85-1 (-) | Always | Below 1 Ω |
| J13-2 - F86-3 (+) | Always | Below 1 Ω |
| J13-1 - F86-1 (-) | Always | Below 1 Ω |
| F132-1 (FR+) or F85-4 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F132-6 (FR-) or F85-2 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F132-2 (FL+) or F86-4 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F132-7 (FL-) or F86-2 (TWL-) - Body ground | Always | 10 kΩ or higher |
| I13-2 or F85-3 (+) - Body ground | Always | 10 kΩ or higher |
| I13-1 or F85-1 (-) - Body ground | Always | 10 kΩ or higher |
| J13-2 or F86-3 (+) - Body ground | Always | 10 kΩ or higher |
| J13-1 or F86-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
NG
Disconnect the F132 radio and display receiver assembly connector.
Disconnect the K5 and L5 rear speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F132-4 (RR+) - K5-2 | Always | Below 1 Ω |
| F132-9 (RR-) - K5-1 | Always | Below 1 Ω |
| F132-3 (RL+) - L5-2 | Always | Below 1 Ω |
| F132-8 (RL-) - L5-1 | Always | Below 1 Ω |
| F132-4 (RR+) or K5-2 - Body ground | Always | 10 kΩ or higher |
| F132-9 (RR-) or K5-1 - Body ground | Always | 10 kΩ or higher |
| F132-3 (RL+) or L5-2 - Body ground | Always | 10 kΩ or higher |
| F132-8 (RL-) or L5-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
NG
Select "Failure Diagnosis" from the "Service Menu" screen.
Select "System Check" from the "Failure Diagnosis" screen.
Select "SPCheck ON" from the "System Check Mode" screen and perform speaker check.
Each speaker outputs sound from the selected audio source properly.
| Result | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 3 speaker assembly does not outputs sound | A |
| Rear speaker assembly does not outputs sound | B |
| Front No. 2 speaker assembly does not outputs sound | C |
| No. 1 speaker with box assembly does not outputs sound | D |
A
B
C
D
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the I13 and J13 front No. 1 speaker assembly connectors.
Disconnect the F89 and F90 front No. 3 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-12 (FR+) -F89-2 (TWR+) | Always | Below 1 Ω |
| F75-27 (FR-) -F89-4 (TWR-) | Always | Below 1 Ω |
| F75-11 (FL+) -F90-2 (TWL+) | Always | Below 1 Ω |
| F75-26 (FL-) -F90-4 (TWL-) | Always | Below 1 Ω |
| I13-2 - F89-1 (+) | Always | Below 1 Ω |
| I13-1 - F89-3 (-) | Always | Below 1 Ω |
| J13-2 - F90-1 (+) | Always | Below 1 Ω |
| J13-1 - F90-3 (-) | Always | Below 1 Ω |
| F75-12 (FR+) or F89-2 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F75-27 (FR-) or F89-4 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F75-11 (FL+) or F90-2 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F132-7 (FL-) or F86-2 (TWL-) - Body ground | Always | 10 kΩ or higher |
| F75-26 (FL-) or F90-4 (TWL-) - Body ground | Always | 10 kΩ or higher |
| I13-2 or F89-1 (+) - Body ground | Always | 10 kΩ or higher |
| I13-1 or F89-3 (-) - Body ground | Always | 10 kΩ or higher |
| J13-2 or F90-1 (+) - Body ground | Always | 10 kΩ or higher |
| J13-1 or F90-3 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
NG
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the K5 and L5 rear speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-13 (RR+) - K5-2 | Always | Below 1 Ω |
| F75-28 (RR-) - K5-1 | Always | Below 1 Ω |
| F75-10 (RL+) - L5-2 | Always | Below 1 Ω |
| F75-25 (RL-) - L5-1 | Always | Below 1 Ω |
| F75-13 (RR+) or K5-2 - Body ground | Always | 10 kΩ or higher |
| F75-28 (RR-) or K5-1 - Body ground | Always | 10 kΩ or higher |
| F75-10 (RL+) or L5-2 - Body ground | Always | 10 kΩ or higher |
| F75-25 (RL-) or L5-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the F52 and F53 front No. 2 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-14 (TWR+) - F52-2 | Always | Below 1 Ω |
| F75-29 (TWR-) - F52-1 | Always | Below 1 Ω |
| F75-9 (TWL+) - F53-2 | Always | Below 1 Ω |
| F75-24 (TWL-) - F53-1 | Always | Below 1 Ω |
| F75-14 (TWR+) or F52-2 - Body ground | Always | 10 kΩ or higher |
| F75-29 (TWR-) or F52-1 - Body ground | Always | 10 kΩ or higher |
| F75-9 (TWL+) or F53-2 - Body ground | Always | 10 kΩ or higher |
| F75-24 (TWL-) or F53-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the M74 No. 1 speaker with box assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-15 (WFR+) - M74-3 (WF+) | Always | Below 1 Ω |
| F75-30 (WFR-) - M74-2 (WF-) | Always | Below 1 Ω |
| F75-8 (WFL+) - M74-4 (WF+) | Always | Below 1 Ω |
| F75-23 (WFL-) - M74-1 (WF-) | Always | Below 1 Ω |
| F75-15 (WFR+) or M74-3 (WF+) - Body ground | Always | 10 kΩ or higher |
| F75-30 (WFR-) or M74-2 (WF-) - Body ground | Always | 10 kΩ or higher |
| F75-8 (WFL+) or M74-4 (WF+) - Body ground | Always | 10 kΩ or higher |
| F75-23 (WFL-) or M74-1 (WF-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG