Home › Suspension › REAR SUSPENSION › REAR LOWER ARM › 2016.10–2019.09
RM32H0E _53 Suspension _059601 REAR SUSPENSION _0292268 REAR LOWER ARM A

REAR SUSPENSION  REAR LOWER ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension arm assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Removal/installation of rear height control sensor sub-assembly LH*1 Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)*1

*1: w/ Height Control Sensor


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 57628C 2.REMOVE REAR FLOOR SIDE MEMBER COVER LH (for 2WD)

Hide 57627A 3.REMOVE REAR FLOOR SIDE MEMBER COVER RH (for 2WD)

Hide 57628C 4.REMOVE REAR FLOOR SIDE MEMBER COVER LH (for AWD)

Hide 57627A 5.REMOVE REAR FLOOR SIDE MEMBER COVER RH (for AWD)

Hide 89408C 6.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)

Hide 48840A 7.REMOVE REAR STABILIZER LINK ASSEMBLY

Hide 48231B 8.REMOVE REAR COIL SPRING

Hide 48258C 9.REMOVE REAR LOWER COIL SPRING INSULATOR

Hide 48740F 10.REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.
C345094

Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly.

NOTICE:

Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.



Hide 48720A 11.REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY

a.
C348393

Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.