Home › Steering › STEERING COLUMN › STEERING WHEEL › 2016.10–2019.09
RM32H0E _55 Steering _059604 STEERING COLUMN _0292297 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point
·

Lane departure alert system (w/ Steering Control)

·

Simple intelligent parking assist system*1

·

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

·

Pre-collision system


(Click here)
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)


NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45130 2.REMOVE HORN BUTTON ASSEMBLY

Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

a.
C365791

Disconnect the 2 connectors from the spiral cable with sensor sub-assembly.


b.

w/ Steering Heater:

i.
C365800

Disconnect the steering heater connector.



c.
C365792C01
1.698,0.656 0.552,0.604 0.552,0.604 1.708,0.469 true 0.344,0.5 0.656,0.656 0.313,0.156 10 false *a
*a Matchmark


Remove the steering wheel assembly set nut.


d.

Put matchmarks on the steering wheel assembly and steering main shaft.


e.
C365793C01
1.51,2.281 0.698,1.625 true 1.135,2.99 1.448,3.146 0.313,0.156 10 false *a 2.948,2.594 3.26,2.75 0.313,0.156 10 false *b 0.323,1.531 0.667,1.708 0.344,0.177 10 true SST
*a Turn
*b Hold


Using SST, remove the steering wheel assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05031)

NOTICE:

Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



Hide 45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 84632 5.REMOVE CRUISE CONTROL MAIN SWITCH

Hide 84250A 6.REMOVE STEERING PAD SWITCH ASSEMBLY