Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM32H0E _55 Steering _059605 POWER ASSIST SYSTEMS _0292301 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1567  Error in Matching of ECUs  


DESCRIPTION

Based on the steering sensor signal, the power steering ECU assembly determines if the correct type of steering sensor is installed.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1567 Error in Matching of ECUs There is a system recognition error
·

Steering sensor (incorrect part)

·

Power steering ECU assembly


EPS warning light: Comes on Ignition switch ON again -

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing, rotation angle sensor initialization and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.CHECK STEERING SENSOR
a.

Check that the steering sensor complies with the specifications of the vehicle.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL

OK:

A steering sensor that complies with the specifications of the vehicle is installed.


NOTICE:

When removing a related part to check it, be sure to follow the appropriate procedures and precautions.


HINT:

If DTC C1567 is output and parts have not been replaced, replace the power steering ECU assembly as it may have an internal malfunction.



Result:
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE POWER STEERING ECU ASSEMBLY

C

REPLACE STEERING SENSOR