Home › Drivetrain › K114 (MULTIDRIVE / CVT) › OIL PRESSURE SENSOR
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292456 OIL PRESSURE SENSOR A

K114 MULTIDRIVE / CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.

Apply Toyota Genuine CVT fluid FE to the O-ring of the oil pressure sensor.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.



b.
C328304C01
0.896,0.333 0.896,0.125 0.896,0.125 1.156,0.125 true 2.458,0.802 2.458,0.552 2.458,0.552 2.771,0.552 false 1.229,0.042 1.688,0.24 0.458,0.198 10 true SST 2.625,1.646 2.938,1.844 0.313,0.198 10 false *a 0.177,0.781 0.406,1.01 0.229,0.229 10 true *b 2.833,0.458 3.292,0.656 0.458,0.198 10 false SST
*a SST Fulcrum Length
*b Torque Wrench Fulcrum Length


Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

SST
09326-22011  

Torque:
Specified tightening torque : 20.6 N*m (210 kgf*cm, 15 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 50 mm (1.9685 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 16.1 N*m (164 kgf*cm, 12 ft.*lbf)




c.

Connect the oil pressure sensor connector.


Hide 51444A 2.INSTALL REAR ENGINE UNDER COVER LH

Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER

Hide 4.INSTALL FRONT WHEEL LH