The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front drive shaft oil seal removal/installation are shown below.
*1: When performing learning using the GTS.
| *a | Heavy object exceeding the capacity of the transmission jack |
Because the continuously variable transaxle assembly is extremely heavy, make sure to follow the work procedures described in the repair manual.
If work is not performed according to the procedures described in the repair manual, there is a danger that the transmission jack could drop and components could fall down.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
36100
1.REMOVE TRANSFER ASSEMBLY
30400B
2.REMOVE CVT TYPE T OIL SEAL
| *a | Protective Tape |
Using a screwdriver with protective tape wound around the tip, pry out the CVT type T oil seal.
Do not damage the continuously variable transaxle assembly.
43410M
3.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the continuously variable transaxle assembly.
Do not damage the continuously variable transaxle assembly.
43410M
4.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
Coat the lip of a new front drive shaft oil seal RH with MP grease.
| *a | -0.5 to 0.5 mm (-0.0197 to 0.0197 in.) |
Using SST and a hammer, install the front drive shaft oil seal RH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as a fluid leak will occur.
30400B
5.INSTALL CVT TYPE T OIL SEAL
Coat the lip of a new CVT type T oil seal with MP grease.
| *a | 3.5 to 4.5 mm (0.138 to 0.177 in.) |
Using SST and a hammer, install the CVT type T oil seal to the continuously variable transaxle assembly.
3.5 to 4.5 mm (0.138 to 0.177 in.)
Be sure to install the CVT type T oil seal in the correct direction.
Make sure to install the CVT type T oil seal as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the CVT type T oil seal.
36100
6.INSTALL TRANSFER ASSEMBLY