The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear door lock with motor assembly removal/installation are shown below.
*1: When performing learning using the GTS.
*2: w/ Stop and start system
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67498
3.REMOVE REAR DOOR REAR FRAME BRACKET
69284D
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
84810
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67628
7.REMOVE REAR DOOR TRIM BRACKET
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER
69240
9.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY
69227L
10.REMOVE REAR DOOR OUTSIDE HANDLE COVER
69060A
11.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws and rear door lock with motor assembly.
When reusing the rear door lock with motor assembly:
Remove the door lock wiring harness seal from the rear door lock with motor assembly.
69740D
12.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
w/o Double Locking System:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw as shown in the illustration.
Disengage the guide to remove the rear door lock remote control cable assembly from the rear door lock with motor assembly.
w/ Double Locking System:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw as shown in the illustration.
Disengage the guide to remove the rear door lock remote control cable assembly from the rear door lock with motor assembly.
69780B
13.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
w/o Double Locking System:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the rear door inside locking cable assembly from the rear door lock with motor assembly.
w/ Double Locking System:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the rear door inside locking cable assembly from the rear door lock with motor assembly.
69730E
14.REMOVE NO. 1 REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the No. 1 rear door lock remote control cable assembly from the rear door lock with motor assembly.