Home › Drivetrain › EC6A (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › 2016.10–2020.08
RM32H0E _52 Drivetrain _059609 EC6A MANUAL TRANSMISSION / TRANSAXLE _0292533 MANUAL TRANSAXLE SYSTEM C

EC6A MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  U010087  Lost Communication with ECM/PCM "A" Missing Message  


DESCRIPTION

The engine control unit and transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU via CAN communication.

If there is a problem in this intercommunication, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
U010087 Lost Communication with ECM/PCM "A" Missing Message All conditions are met for 1.25 seconds or more (1-trip detection logic):
·

The ignition switch is ON and battery voltage is 9.5 V or higher

·

There is no communication between the engine control unit and transmission control unit.


ECM Does not come on DTC stored SAE Code:
U0100

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Check that the battery voltage is 9.5 V or more.

2.

Turn the ignition switch to ON.



PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U010087)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Trouble Codes
50001 373

d.

Check if DTCs are output.

Result:
Result Proceed to
Only DTC U010087 is output A
DTC U010087 and other DTCs are output B




A

2.REPLACE ECM

B

2.REPLACE ECM

Result:
Proceed to
NEXT



NEXT