Home › Engine / Hybrid System › 3ZR-FAE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM32H0E _51 Engine / Hybrid System _059726 3ZR-FAE ENGINE MECHANICAL _0292815 FRONT CRANKSHAFT OIL SEAL A

3ZR-FAE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443C 3.REMOVE REAR ENGINE UNDER COVER RH

Hide 51107A 4.REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 16361A 5.REMOVE FAN AND GENERATOR V BELT

Hide 13471 6.REMOVE CRANKSHAFT PULLEY

a.
A289823C08
1.354,1.635 2.417,0.667 false 1.719,1.979 2.396,0.688 false 0.552,3.01 0.76,3.01 false 0.375,2.896 0.792,3.146 0.417,0.25 10 false *a 1.552,3.156 1.885,3.385 0.333,0.229 10 false *b 2.448,0.542 2.896,0.885 0.448,0.344 10 false SST
*a Hold
*b Turn


Using SST to hold the crankshaft pulley, loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.

SST
09213-54015  (91551-00850)
09330-00021  


b.
A312724C01
1.708,2.396 2.365,0.594 2.365,0.594 2.646,0.594 true 0.115,1.74 0.427,1.938 0.313,0.198 10 false *a 1.5,3.177 1.813,3.375 0.313,0.198 10 false *b 2.719,0.521 3.177,0.719 0.458,0.198 10 false SST
*a Hold
*b Turn


Using SST, remove the crankshaft pulley and crankshaft pulley set bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

HINT:

Apply lubricant to the threads and end of SST.



Hide 11302A 7.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A200713C04
1.781,0.792 2.031,1 2.031,1 2.146,1 true 2.167,0.917 2.333,1.094 0.167,0.177 10 false *a
*a Protective Tape


Using a screwdriver, pry out the timing chain cover oil seal.

NOTICE:

After removal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.


HINT:

Tape the screwdriver tip before use.