Home › Drivetrain › K114 (MULTIDRIVE / CVT) › OIL PAN › 2016.10–2019.09
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292837 OIL PAN A

K114 MULTIDRIVE / CVT  OIL PAN  INSTALLATION  


PROCEDURE

Hide 35330D 1.INSTALL OIL STRAINER ASSEMBLY

HINT:

Perform this procedure only when replacement of the oil strainer assembly is necessary.


a.

Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the oil strainer assembly.

NOTICE:

Ensure that the O-ring is not twisted.



b.

Coat the 2 bolts with Toyota Genuine CVT fluid FE.


c.
C409886N01
2.625,0.604 2.781,0.802 0.156,0.198 10 true A 0.833,1.875 0.958,2.031 0.125,0.156 10 true B

Temporarily install the oil strainer assembly to the transmission valve body assembly with the 2 bolts.

NOTICE:
·

Make sure that the transmission wire is not pinched.

·

Be careful not to damage the O-ring.



HINT:
Bolt Length
·

Bolt (A): 16 mm (0.630 in.)

·

Bolt (B): 30 mm (1.18 in.)




d.

Tighten the 2 bolts.

Torque:
10.8 N*m (110 kgf*cm, 8 ft.*lbf)


Hide 35394D 2.INSTALL OIL CLEANER (CVT) MAGNET

a.
C295678C02
1.448,0.885 2.26,0.885 false 1.76,1.51 1.76,0.885 false 1.271,0.823 1.583,1.021 0.313,0.198 10 true *1
*1 Oil Cleaner (CVT) Magnet


Install the 2 oil cleaner (CVT) magnets to the transaxle oil (CVT) pan sub-assembly.


Hide 35106L 3.INSTALL TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY

a.

Clean the transaxle oil (CVT) pan sub-assembly installation surface of the continuously variable transaxle assembly.


b.

Install a new transaxle oil pan (CVT) gasket to the transaxle oil (CVT) pan sub-assembly.


c.

Install the transaxle oil (CVT) pan sub-assembly to the continuously variable transaxle assembly with the 19 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


d.

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly.

Torque:
1.7 N*m (17 kgf*cm, 15 in.*lbf)


e.

Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the transaxle oil (CVT) pan sub-assembly.

HINT:

Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.



f.

Using a 10 mm hexagon socket wrench, install a new gasket and drain plug to the transaxle oil (CVT) pan sub-assembly.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 4.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 5.INSPECT FOR FLUID LEAK

Hide 51444A 6.INSTALL REAR ENGINE UNDER COVER LH

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER