Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293876 CRANKSHAFT POSITION SENSOR A

3ZR-FAE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A393501C01
1.688,0.979 1.958,0.688 false 1.979,0.583 2.292,0.781 0.313,0.198 10 false *1
*1 O-ring


Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




c.

Connect the crankshaft position sensor connector.


Hide 51443C 3.INSTALL REAR ENGINE UNDER COVER RH

Hide 4.INSTALL FRONT WHEEL RH