Home › Engine / Hybrid System › 3ZR-FAE (LUBRICATION) › LUBRICATION SYSTEM
RM32H0E _51 Engine / Hybrid System _060036 3ZR-FAE LUBRICATION _0294091 LUBRICATION SYSTEM G

3ZR-FAE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up and stop the engine, then wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.

If the level is low, check for engine oil leaks and add engine oil to the full level mark.

NOTICE:

Do not add engine oil to above the full level mark.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the engine oil for deterioration, water intrusion, discoloration or thinning.

If the quality is visibly poor, replace the engine oil and oil filter element.


Hide 3.CHECK OIL PRESSURE

CAUTION:
·
A345137

When working near the engine room while the engine has started or the power source mode is ignition switch to ON (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc.

·

Touching the fan and generator V belt or rotating components such as the fan, etc. could result in your hand or clothing getting caught and pulled in.


·
A340359C11
0.375,1.135 0.75,1.281 true 0.135,1.031 0.448,1.229 0.313,0.198 10 false *a
*a High temperature areas


Do not touch the engine or exhaust manifold converter sub-assembly when they are hot.

·

Touching the engine or exhaust manifold converter sub-assembly when they are hot could result in burns.


·
A397110

To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.

·

Removing the engine oil pressure switch assembly while the engine is hot could result in burns caused by contact with hot engine oil.



NOTICE:

Clean the hose and adapter of the oil pressure gauge before and after measurement.


a.

Remove the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>3ZR-FAE (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL

CAUTION:

Make sure the engine is cold when removing the engine oil pressure switch assembly to prevent burns caused by hot engine oil.



b.
A173089

Install an oil pressure gauge with the adapter.


c.

Warm up the engine.

HINT:

After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).



d.

Check the engine oil pressure.

Standard Oil Pressure:
Engine Condition Oil Pressure
Idling 25 kPa (0.3 kgf/cm2, 3.6 psi) or higher
3000 rpm 150 to 400 kPa (1.5 to 4.1 kgf/cm2, 22 to 58 psi)


If the result is not as specified, check the quality of the engine oil and check the oil paths for clogging. Repair or replace if necessary. If the engine oil pressure is still not as specified, check the oil pump assembly.

Click hereEngine / Hybrid System>3ZR-FAE (LUBRICATION)>OIL PUMP>INSPECTION


e.

Remove the oil pressure gauge with the adapter.

CAUTION:

Make sure the engine is cold when removing the oil pressure gauge to prevent burns caused by hot engine oil.



f.

Install the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>3ZR-FAE (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION


g.

Inspect for engine oil leaks.

Click hereGeneral>MAINTENANCE>3ZR-FAE OIL AND OIL FILTER>REPLACEMENT