Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294918 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1224  NE Signal  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives engine speed signals from the ECM via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1224 NE Signal The vehicle speed is 6 km/h (4 mph) or more, the +BS terminal voltage is between 9.6 and 16.5 V, and the engine speed signal is more than 12800 rpm for 2.5 seconds or more.
·

CAN communication system

·

ECM



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.CHECK SFI SYSTEM

B

2.CHECK SFI SYSTEM
a.

Check if SFI system DTCs are output.

for 8NR-FTS: Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine > Trouble Codes
50001 372

for 3ZR-FAE: Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine and ECT > Trouble Codes
50001 234

Result:
Result Proceed to
DTCs are not output. (for 8NR-FTS) A
DTCs are not output. (for 3ZR-FAE) B
DTCs are output. (for 8NR-FTS) C
DTCs are output. (for 3ZR-FAE) D



A

B

C

D