The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ECM removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.
Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>3ZR-FAE BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11212
3.REMOVE NO. 2 CYLINDER HEAD COVER
4.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
53141F
5.REMOVE RADIATOR COVER
17751
6.REMOVE NO. 1 AIR CLEANER INLET
17701
7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
Remove the 2 bolts and air cleaner case sub-assembly from the vehicle.
89661
8.REMOVE ECM
Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the No. 1 relay block cover from the No. 1 engine room relay block.
Disconnect the 3 connectors from the engine room relay block assembly.
Disengage the 2 claws to separate the engine wire from the No. 1 engine room relay block.
Remove the bolt, nut and ECM.
If the ECM has been struck or dropped, replace it.
89667E
9.REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket from the ECM.
89668
10.REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket from the ECM.