| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| P0805 | Clutch Position Sensor "A" Circuit | Clutch stroke sensor signal from ECM cannot be received for 0.3 seconds or more | ·
ECM ·
CAN communication system ·
Skid control ECU (brake actuator assembly) |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light blinks (red) when the ignition switch is first turned to ON.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Check for DTC.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P0805 and a CAN DTC are output at the same time | A |
| DTC P0805 is output and the MIL is illuminated | B |
| Only DTC P0805 is output (for LHD) | C |
| Only DTC P0805 is output (for RHD) | D |
| DTCs are not output | E |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
for EC69: Click hereDrivetrain>EC69 (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
for EC6A: Click hereDrivetrain>EC6A (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
D
E
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING