Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295069 CAMSHAFT POSITION SENSOR A

8NR-FTS ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 11101W 1.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A392705

Disconnect the camshaft position sensor connector.


b.

Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 55737B 3.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

Hide 55735A 4.REMOVE WATER GUARD PLATE LH

Hide 55736D 5.REMOVE COWL BODY MOUNTING REINFORCEMENT LH

Hide 55735C 6.REMOVE COWL BODY MOUNTING REINFORCEMENT RH

Hide 55701J 7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 8.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 17705 9.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 11401M 10.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A392706C01
1.781,0.74 1.969,0.917 0.188,0.177 10 true *1 0.823,0.031 0.99,0.198 0.167,0.167 10 true *a
*1 Fuel Tube Sub-assembly
*a Sensor Wire Connector


Disconnect the fuel tube sub-assembly from the hose clamp.


b.

Remove the 2 bolts and separate the fuel vapor feed pipe from the cylinder head cover sub-assembly.


c.

Disconnect the sensor wire connector.


d.
A392707C01
0.719,0.969 1.094,0.427 1.094,0.427 1.302,0.427 true 0.375,1.031 0.469,0.313 0.469,0.313 0.667,0.313 true 0.677,0.167 0.854,0.385 0.177,0.219 10 true *a 1.292,0.333 1.604,0.51 0.313,0.177 10 true SST
*a 10 mm Union Nut Wrench


Using SST and a 10 mm union nut wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

SST
09961-00950  

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



e.
A352553

Disconnect the camshaft position sensor connector to remove the camshaft position sensor from the sensor wire.