Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295070 CRANKSHAFT POSITION SENSOR A

8NR-FTS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Install the crankshaft position sensor to the timing chain cover assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

If reusing the crankshaft position sensor, be sure to inspect the O-ring.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




b.

Connect the crankshaft position sensor connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK

Hide 51443C 3.INSTALL REAR ENGINE UNDER COVER RH

Hide 4.INSTALL FRONT WHEEL RH