89615
1.INSTALL KNOCK SENSOR
Perform "Inspection After Repair" after replacing the knock sensor.
Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
| *a | Top |
| *b | Front of Engine |
| *c | Mark |
| *d | 12.5° |
| *e | 5° |
Install the knock sensor to the cylinder block sub-assembly with the bolt so that the knock sensor installation position is as shown in the illustration.
If the knock sensor has been struck or dropped, replace it.
Make sure that the knock sensor is in the correct position.
Connect the knock sensor connector.
Install the No. 4 engine wire with the bolt.
27020
2.INSTALL GENERATOR ASSEMBLY
for DENSO Made:
Click herePower Source / Network>8NR-FTS (BATTERY / CHARGING)>GENERATOR (for DENSO Made)>INSTALLATION
for VALEO Made:
Click herePower Source / Network>8NR-FTS (BATTERY / CHARGING)>GENERATOR (for VALEO Made)>INSTALLATION
3.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the knock sensor.
Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION