89465
1.INSTALL HEATED OXYGEN SENSOR
for 2WD:
| *a | Torque Wrench Fulcrum Length |
Using SST, install the heated oxygen sensor to the front exhaust pipe assembly (TWC: Rear Catalyst).
If the heated oxygen sensor has been struck or dropped, replace it.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
39 N*m (398 kgf*cm, 29 ft.*lbf)
Install the wire harness clamp bracket to the heated oxygen sensor.
Engage the wire harness clamp.
for AWD:
| *a | Torque Wrench Fulcrum Length |
Using SST, install the heated oxygen sensor to the front exhaust pipe assembly (TWC: Rear Catalyst).
If the heated oxygen sensor has been struck or dropped, replace it.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
39 N*m (398 kgf*cm, 29 ft.*lbf)
Install the wire harness clamp bracket to the heated oxygen sensor.
Engage the wire harness clamp.
17410
2.INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
3.INSPECT FOR EXHAUST GAS LEAK