Home › Engine / Hybrid System › 3ZR-FAE (COOLING) › WATER PUMP › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _060196 3ZR-FAE COOLING _0295092 WATER PUMP A

3ZR-FAE COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

*2: w/ Stop and start system

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision syatem
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 2.DRAIN ENGINE COOLANT

Hide 27020 3.REMOVE GENERATOR ASSEMBLY

Hide 16620 4.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 16100 5.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A395335

Remove the 6 bolts and engine water pump assembly.


b.
A395336

Remove the gasket.