Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › 2016.10–2020.08
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295246 BATTERY CURRENT SENSOR A

8NR-FTS BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Engage the 2 claws and install the battery state sensor assembly to the battery current sensor holder.


b.

Engage the clamp and connect the engine wire to the battery state sensor assembly.


c.

Connect the battery state sensor assembly connector.


d.

Connect the battery state sensor assembly to the battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


e.

Connect the engine wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION