The engine stop and start ECU detects whether the engine hood is open or closed based on a signal received from the engine hood courtesy switch built into the hood lock assembly.
The engine stop and start ECU prohibits starting of the engine by stop and start control and changes the mode to "stalled" if the engine hood is open with the clutch pedal is released while the engine is stopped by stop and start control.
Before performing this step, check that the engine hood can be opened by pulling the hood lock control cable.
Connect the GTS to the DLC3.
Turn the ignition switch to ON
Turn the GTS on.
Enter the following menus: Powertrain / Stop and Start / Data List / Hood Courtesy Switch.
According to the display on the GTS, read the Data List.
| Tester Display |
|---|
| Hood Courtesy Switch |
| Tester Display | Condition | Normal Condition |
|---|---|---|
| Hood Courtesy Switch | Engine hood closed | ON |
| Engine hood open | OFF |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the hood lock assembly (hood courtesy switch).
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL
Inspect the hood lock assembly (hood courtesy switch).
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A8 hood lock assembly (hood courtesy switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A8-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A62 engine stop and start ECU connector.
Disconnect the A8 hood lock assembly (hood courtesy switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A62-7 (BNT1) - A8-1 (+) | Always | Below 1 Ω |
| A62-7 (BNT1) - Body ground and other terminals | Always | 10 kΩ or higher |
| A8-1 (+) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG