Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297206 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A45  Vehicle Speed Sensor  


DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A45 Vehicle Speed Sensor A fail flag is transmitted from the skid control ECU
·

Vehicle stability control system

·

Blind spot monitor sensor LH (Master)

·

Blind spot monitor sensor RH (Slave)



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


PROCEDURE

1.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for vehicle stability control system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

OK:

Vehicle stability control system DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK DTC

NG

2.CHECK DTC
a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON.


c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC C1A45 is output ("Blind Spot Monitor Master"). B
DTC C1A45 is output ("Blind Spot Monitor Slave"). C



A

B

REPLACE BLIND SPOT MONITOR SENSOR LH (MASTER)

C