Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY › 2016.10–2019.09
RM32H0E _57 Power Source / Network _060596 POWER DISTRIBUTION _0297232 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the No. 1 integration relay removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
E353734C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the No. 1 relay block cover as shown in the illustration.


Hide 82641 4.REMOVE NO. 1 INTEGRATION RELAY

a.
E353736C01
1.333,1.833 1.75,1.625 true 1.135,1.729 1.302,1.896 0.167,0.167 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws.


b.

Pull up the No. 1 integration relay as shown in the illustration.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.



c.
E353738

Disconnect the 2 connectors to remove the No. 1 integration relay.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.