This DTC is stored when the blind spot monitor sensor LH detects a short to +B in the outer rear view mirror indicator LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB0 | Short to +B in Outer Mirror Indicator(Master) | Both of the following conditions are met:
·
The blind spot monitor system is on ·
The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time |
·
Outer mirror LH ·
Outer rear view mirror assembly LH ·
Wire harness or connector ·
Blind spot monitor sensor LH (Master) |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Turn the ignition switch off.
Turn the ignition switch to ON.
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector (to blind spot monitor sensor LH (Master)) |
Disconnect the M62 blind spot monitor sensor LH (Master) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| M62-4 (OMIL) - Body ground | Ignition switch to ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector (to blind spot monitor sensor LH (Master)) |
Disconnect the IND1 outer mirror LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| M62-4 (OMIL) - Body ground | Ignition switch to ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector (to blind spot monitor sensor LH (Master)) |
Disconnect the J11*1 or J7*2 outer rear view mirror assembly LH connector.
*1: for TMC Made
*2: for TMMT Made
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| M62-4 (OMIL) - Body ground | Ignition switch to ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG