Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0292802 REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL  REPLACEMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft oil seal LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
·

Rear height control sensor sub-assembly LH*1

·

Suspension, tires, etc.

(The vehicle height changes because of suspension or tire replacement)


Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

*1: w/ Height Control Sensor


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42340D 2.REMOVE REAR DRIVE SHAFT OIL SEAL LH

a.
C360117N01
1.854,2.635 1.396,2.292 true 1.896,2.573 2.292,2.771 0.396,0.198 10 true SST

Using SST, tap out the rear drive shaft oil seal LH.

SST
09308-00010  

NOTICE:

Be careful not to damage the rear differential carrier sub-assembly.



Hide 42340D 3.INSTALL REAR DRIVE SHAFT OIL SEAL LH

a.

Coat the lip of a new rear drive shaft oil seal LH with MP grease.


b.
C360118C01
0.615,2.563 0.979,2.323 true 1.26,0.094 1.573,0.25 0.313,0.156 10 false *a 0.24,2.531 0.615,2.74 0.375,0.208 10 true SST
*a Depth


Using SST and a hammer, install the rear drive shaft oil seal LH to the rear differential carrier sub-assembly.

SST
09223-00010  

Standard Depth:

6.7 to 7.7 mm (0.264 to 0.303 in.)


NOTICE:
·

Tap the oil seal uniformly so that the oil seal is straight.

·

Do not tap the oil seal in too far.