This DTC is stored when the telematics transceiver detects an open or short in the manual (SOS) switch indicator (green) circuit of the manual (SOS) switch.
The manual (SOS) switch indicator (green) illuminates after the ignition switch is turned to ON.
If the telematics system is not active, the manual (SOS) switch indicator (green) will turn off.
If the telematics system is active, the manual (SOS) switch indicator (green) will blink while communicating with the call center.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1571 | Green LED Error | Current for the manual (SOS) switch indicator (green) exceeds malfunction threshold for 10 seconds when the ignition switch is ON. | ·
Telematics transceiver ·
Map light assembly ·
Mayday switch assembly (manual (SOS) switch) ·
Wire harness or connector |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>REGISTRATION
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 10 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Component with harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R4-5 (IND2) - R4-1 (GND3) | 2 seconds after ignition switch turned to ON → Ignition switch off | 2 to 5 V
→ Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the mayday switch assembly (manual (SOS) switch).
Click hereAudio / Visual / Telematics>TELEMATICS>MAYDAY SWITCH>REMOVAL
Inspect the mayday switch assembly (manual (SOS) switch).
Click hereAudio / Visual / Telematics>TELEMATICS>MAYDAY SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F51 telematics transceiver connector.
Disconnect the R4 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F51-12 (IND2) - R4-5 (IND2) | Always | Below 1 Ω |
| F51-12 (IND2) or R4-5 (IND2) - Body ground | Always | 10 kΩ or higher |
| F51-26 (SIG-) - R4-1 (GND3) | Always | Below 1 Ω |
| F51-26 (SIG-) or R4-1 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT