77754B
1.INSTALL CHARCOAL CANISTER OUTLET HOSE
Engage the 2 clamps to install the charcoal canister outlet hose to the fuel tank assembly.
77209F
2.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Engage the 3 clamps to install the fuel tank main tube sub-assembly to the fuel tank assembly.
77026A
3.INSTALL NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Engage the 4 clamps to install the No. 1 fuel evaporation tube sub-assembly to the fuel tank assembly.
77651A
4.INSTALL NO. 1 FUEL TANK CUSHION
Install 2 new No. 1 fuel tank cushions to the fuel tank assembly.
77100
5.INSTALL FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then temporarily install the fuel tank assembly with No. 1 fuel tank band sub-assemblies with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
6.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
77026A
7.CONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Connect the No. 1 fuel evaporation tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
77213E
8.CONNECT FUEL TANK TO FILLER PIPE HOSE
| *a | Top of Vehicle |
| *b | 120° (Clamp Bolt Area) |
Connect the fuel tank to filler pipe hose to the fuel tank assembly and tighten the clamp to secure it.
Make sure the clamp and fuel tank to filler pipe hose are positioned within the area shown in the illustration.
9.CONNECT FUEL TANK BREATHER TUBE
Connect the fuel tank breather tube to the fuel tank filler pipe sub-assembly.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
77754B
10.CONNECT CHARCOAL CANISTER OUTLET HOSE
Connect the charcoal canister outlet hose to the fuel tank filler pipe sub-assembly and slide the hose clip to secure it.
77641A
11.INSTALL NO. 1 FUEL TANK PROTECTOR
Install the No. 1 fuel tank protector to the fuel tank assembly with the nut and 4 clips.
57628C
12.INSTALL REAR FLOOR SIDE MEMBER COVER LH (w/ Cover)
Install the rear floor side member cover LH with the clip (B).
Install the 3 bolts and clip (A).
57627A
13.INSTALL REAR FLOOR SIDE MEMBER COVER RH (w/ Cover)
Install the rear floor side member cover RH with the clip.
Install the 3 bolts.
17430
14.INSTALL TAIL EXHAUST PIPE ASSEMBLY
77020A
15.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
16.ADD FUEL