Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD)
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298586 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

a.

Install the brake pedal pad from the brake pedal support assembly.


Hide 47110 2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the nut to the brake pedal support assembly.


b.
C366046N02
0.635,1.417 0.792,1.615 0.156,0.198 10 true 1 2.385,0.531 2.542,0.729 0.156,0.198 10 true 2 0.656,0.563 0.813,0.76 0.156,0.198 10 true 3 2.448,1.396 2.604,1.594 0.156,0.198 10 true 4

Temporarily install the brake pedal support assembly with 2 new clips.


c.

Install the 4 nuts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)

NOTICE:

Tighten the nuts in the order shown in the illustration.



d.

Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

Torque:
23.6 N*m (241 kgf*cm, 17 ft.*lbf)


e.

w/ Brake pedal Load Sensing Switch:

i.

Engage the clamp to install the wire harness to the brake pedal support assembly.


ii.

Connect the brake pedal load sensing switch connector.



Hide 47264A 3.INSTALL PUSH ROD PIN

a.
C342031C02
0,0 0,0 false
V100145

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to the push rod pin.


b.
C366043

Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

NOTICE:

Be sure to install the push rod pin in the correct direction.



Hide 47101A 4.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support assembly and push rod pin.


Hide 84345 5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 6.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 55401E 7.INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 8.INSPECT AND ADJUST BRAKE PEDAL