Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296123 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E351173

Insert the stop light switch assembly until the threaded sleeve hits the pedal.

NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E351174E01
1.906,1.927 2.063,2.125 0.156,0.198 10 false a

Turn the stop light switch assembly 1/4 clockwise to install it.

Torque:

1.5 N*m (15 kgf*cm, 13 in.*lbf) or less


NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



c.

Connect the connector.


d.

Check the protrusion of the plunger.

Protrusion of the Plunger
Area Measurement
a 0.6 to 2.6 mm (0.0236 to 0.102 in.)


e.

If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

for LHD:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT


for RHD:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT


NOTICE:

Do not depress or support the brake pedal.



Hide 87211 2.INSTALL NO. 1 AIR DUCT

Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62112 4.INSTALL COWL SIDE TRIM BOARD LH

Hide 67914 5.INSTALL FRONT DOOR SCUFF PLATE LH