Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0298590 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace the front axle hub sub-assembly.



PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Install the front speed sensor to the steering knuckle with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Keep the tip of the front speed sensor and installation hole free of foreign matter.

·

Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

·

After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.




b.
C369994C01
2.094,1.667 2.729,1.208 2.729,1.208 2.25,1.104 true 1.323,1.781 1.438,1.427 true 2.76,1.094 3.01,1.323 0.25,0.229 10 true *a 1.208,1.813 1.448,2.042 0.24,0.229 10 true *b
*a Hook
*b Clamp


Engage the clamp to the front shock absorber assembly.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



c.

Engage the 2 hooks of front speed sensor clamp to the front shock absorber assembly.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



d.
C343313

Install the front flexible hose to the front shock absorber assembly with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


e.

Install the 2 front speed sensor clamps with the 2 bolts.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



f.

Engage the clamp to the vehicle body.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



g.

Engage the clamp to the vehicle body.

NOTICE:

Do not twist the front speed sensor wire harness when installing it.



h.

Connect the connector.


i.

Return the front fender liner to its original position.


Hide 53876A 2.INSTALL FRONT FENDER LINER

a.

Install the front fender liner with the 3 clips.


b.

Install the 4 screws.


Hide 75852 3.INSTALL ROCKER PANEL MOULDING

Hide 4.INSTALL FRONT WHEEL