Home › Drivetrain › K313 (MULTIDRIVE / CVT) › OIL COOLER
RM32H0E _52 Drivetrain _059624 K313 MULTIDRIVE / CVT _0299310 OIL COOLER A

K313 MULTIDRIVE / CVT  OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission oil cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 4.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 33493C 5.REMOVE TRANSMISSION OIL COOLER

a.
C289707C01
0.448,1.198 0.656,1.385 0.208,0.188 10 true *1 3.083,0.604 3.271,0.792 0.188,0.188 10 true *2
*1 No. 3 Water By-pass Hose
*2 No. 4 Water By-pass Hose


Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the transmission oil cooler.


b.
C289708

Remove the 3 bolts and transmission oil cooler from the continuously variable transaxle assembly.


c.

Remove the 2 O-rings from the transmission oil cooler.