Home › Drivetrain › K313F (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › 2016.10–2018.05
RM32H0E _52 Drivetrain _059618 K313F MULTIDRIVE / CVT _0300013 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K313F MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P175009  Brake ECU Malfunction  


DESCRIPTION

This DTC is stored if the ECM receives a malfunction signal from the brake actuator assembly (skid control ECU).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P175009 Brake ECU Malfunction The ECM receives a malfunction signal from the skid control ECU (brake actuator assembly) for 3 seconds (1 trip detection logic). Vehicle stability control system Comes on (Euro-OBD)
Does not come on (Except Euro-OBD)
DTC stored SAE Code:
P1750

CAUTION / NOTICE / HINT

HINT:

After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Drive the vehicle at 20 km/h (12 mph) or more for 9 seconds or more.



PROCEDURE

1.CHECK DTC OUTPUT (BRAKE CONTROL SYSTEM)
a.

Check for brake control system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B