The main body ECU (multiplex network body ECU) detects auto high beam switch signals. The automatic high beam system can be turned on and off by operating the integration control and panel assembly (automatic high beam switch).
Before replacing the main body ECU (multiplex network body ECU), refer to refer to Service Bulletin.*1
*1: w/ Entry and Start System
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Auto High Beam Main Switch | Auto high beam switch signal | ON or OFF | ON: Auto high beam switch pressed
OFF: Auto high beam switch not pressed |
- |
| Tester Display |
|---|
| Auto High Beam Main Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the auto high beam switch.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM MAIN SWITCH>REMOVAL
Inspect the auto high beam switch.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM MAIN SWITCH>INSPECTION
Auto high beam switch is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F15 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F6-6 (+B) - F15-17 (AHBI) | Always | Below 1 Ω |
| F6-6 (+B) or F15-17 (AHBI) - Body ground | Always | 10 kΩ or higher |
| F6-3 (E) - Body ground | Always | Below 1 Ω |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C